Dell Latitude 7380 Owner's Manual

Removing display assembly

Follow the procedure in Before working inside your computer .
Remove the:
- NOTE: To identify the number of screws, see screw list
To remove the display assembly:
1. Un route the WLAN and WWAN cables from the routing channels [1].
2. Remove the M2.0 x 5.0 screws that secures the eDP bracket [2].
3. Lift the eDP bracket from the eDP cable [3].
4. Disconnect the eDP cable from its connector on the system board [4].
  - NOTE: In touch-configuration system, you need to remove the touch display cable connected to its connector on the system board.
5. Remove the adhesive tape that secures the eDP cable [5].
  - NOTE: In touch-configuration system you will find both eDP cable and touch display cable secured with adhesive tape.
To remove the display assembly:
1. Open the display of the computer and lay it on a flat surface at 180 degree angle
2. Remove the M2.5 x 4.0 screws that secure the display hinge to the display assembly [1].
3. Lift the display assembly from the computer.